Chanda Glendinning on thu 26 jun 08
Bill, Cindy & Mark, Arnold and Tim,
Thank you all for your VERY prompt and friendly responses regarding the
kilns. I am going to go take a look at them myself nest week, and will let
you know if I find out more. I had looked at the Amaco website, but not
found the "model #" given to me (since it was probably info on the
controller). I want to make sure they are worth transporting and storing
for fututre use at the Art Center.
I'll write down every bit of info I find, and then go from there. By now I
should know where to find the kiln info versus the controller/sitter info,
provided I am the one doing the looking....
Thank you!!
Chanda
| |
|
