Linda Mccaleb on sat 30 oct 10
=3DA0=3DA0 Hello folks,=3D0A=3DA0 =3DA0I feel so=3DA0 stupid, I should have=
this memori=3D
zed by now. I need to bisque a =3D0Aload, and lost my fireing schedule. I h=
av=3D
e a programmable TNF-82 Paragon kiln. =3D0AIt has 4 programmable zones. It =
al=3D
so fires by the cone, which fires hot. We =3D0Atried to adjust it, and we h=
av=3D
e the right thermocouple but it is about 40 =3D0Adegrees F off too high. I =
th=3D
ink maybe a little higher. =3D0A=3D0A=3DA0 Well I can fire the bisque just =
fine, =3D
it doesn't make a difference too much if =3D0Ayou are off a little. But I n=
ee=3D
d to fire at cone 5 and cone 6 too. =3D0A=3D0A=3DA0 Does anyone have a copy=
of a =3D
fireing schedule that can be taken off your =3D0Acomputer and sent? Or at l=
ea=3D
st maybe if a kind sole could spend their precious =3D0Atime (I know I'm as=
ki=3D
ng a lot) to write out the medium fireing schedule for =3D0Acones 5 and 6. =
Af=3D
ter the weekend I will call PARAGON and have them send me a =3D0Abook. I mi=
sp=3D
laced it. But maybe someone has a TNF-82 and can send me the =3D0Ainformati=
on=3D
. I would be eternally grateful. =3D0A=3D0A=3DA0 I just have to get a few t=
hings =3D
fired before the end of the week, and there is =3D0Asome time consuming gla=
ze=3D
techniques I'm going to do, so that will take a while, =3D0Aand then I hav=
e =3D
to fire immediately after.=3D0A=3DA0 Thanks so much, I will be waiting with=
bai=3D
ted breath,=3D0A=3DA0 Linda=3D0A=3D0A=3D0A
Arnold Howard on mon 1 nov 10
Linda, here is the link to the Sentry controller manual:
http://www.paragonweb.com/files/manuals/IM204_Sentry12key_Conefire_2007.pdf
The firing schedules programmed into Cone-Fire mode are on
pages 32 -33.
Sincerely,
Arnold Howard
Paragon Industries, L.P., Mesquite, Texas USA
ahoward@paragonweb.com / www.paragonweb.com
| |
|
