Cheryl L Litman on tue 9 feb 99
By:
*using the vent
*having bottom shelves on 1" posts
*always having top shelves just under the lid to hold the heat in
*leaving either a 1" gap between half shelves or staggering them
*loading the kiln move "evenly"
*doing a slower firing
I evened out my firings from top to bottom. Didn't test one variable at
a time so I can't say which are most important in terms of even firing,
but altogether they work.
Cheryl Litman
Somerset, NJ
email: cheryllitman@juno.com
On Mon, 8 Feb 1999 13:35:11 EST Mimi Stadler writes:
>----------------------------Original
>message----------------------------
>Hello Laura-
> I don't think an Envirovent will even out kiln temperature. I
>have had one
>for 10 years. There is a difference of more than a cone (close to 2)
>from the
>bottom and middle, which are fairly close in temp, to the top, which
>is much
>cooler.
>Mimi Stadler
>
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
| |
|
