Daryl Baird on thu 22 apr 99
Greetings All!
It's good to see a thread about extruders, one of my favorite topics. Good, too
see Bonnie receiving such informed advice to help with her selection.
I thought I'd give you a progress report about The Extruder Book to be published
The American Ceramic Society. It is due out this November. Hopefully in hard cov
course, as I'm still finishing the manuscript and fitting in the photographs --
received from Clayarters.
By the way, Clayart receives a very gracious acknowledgement in the book. I'm gr
to those of you on the list who contributed so much in terms of photos and techn
assistance.
With thirteen chapters in the can, er, barrel and two and a half to go, I'll sig
By the way, I hope to do as much as I can to give extruding more visibility at t
An extruder art exhibit, panel discussion, and more equipment on the vendor floo
need to be bandied around. Comments?
Regards,
Daryl Baird
Loveland, CO
Download Neoplanet at http://www.neoplanet.com
Dannon Rhudy on fri 23 apr 99
-----------------------------------------
>By the way, I hope to do as much as I can to give extruding more
visibility at t
>An extruder art exhibit, panel discussion, and more equipment on the
vendor floo
Comments?...
----------------------------------------------------
Some of your message seems to be missing, no? An extruded forms exhibit
would be interesting. Go for it.
Regards,
Dannon Rhudy
potter@koyote.com
>
>Regards,
>
>Daryl Baird
>Loveland, CO
>
>
>Download Neoplanet at http://www.neoplanet.com
>
Daryl Baird on tue 27 apr 99
Greetings All!
It's good to see a thread about extruders, one of my favorite topics. Good, too
see Bonnie receiving such informed advice to help with her selection.
I thought I'd give you a progress report about The Extruder Book to be published
The American Ceramic Society. It is due out this November. Hopefully in hard cov
course, as I'm still finishing the manuscript and fitting in the photographs --
received from Clayarters.
By the way, Clayart receives a very gracious acknowledgement in the book. I'm gr
to those of you on the list who contributed so much in terms of photos and techn
assistance.
With thirteen chapters in the can, er, barrel and two and a half to go, I'll sig
By the way, I hope to do as much as I can to give extruding more visibility at t
An extruder art exhibit, panel discussion, and more equipment on the vendor floo
need to be bandied around. Comments?
Regards,
Daryl Baird
Loveland, CO
| |
|
