Earl Brunner on fri 30 jun 00
I think this is a way complicated way to get around bat
pins. Just drill the wheel head.
It's no big deal. Honest, have done it several times.
You might want to pick a standard pin distance, such as the
Brent one.
clay donuts on the wheelhead ANY day before I would try this
three dowel thingy.
IMHO
Carole Fox wrote:
>
> Dear Kathleen,
> Very cool solution to the bat pin problem. Would you mind telling us how you attached those dowels, and to what type of bat?
> Thanks.
>
> Carole - in Elkton, MD where last night we saw a magnificent rainbow!
>
> Carole Fox
> cfox@dca.net
>
> ______________________________________________________________________________
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached at melpots@pclink.com.
--
Earl Brunner
http://coyote.accessnv.com/bruec
mailto:bruec@anv.net
Carole Fox on fri 30 jun 00
Dear Kathleen,
Very cool solution to the bat pin problem. Would you mind telling us =
how you attached those dowels, and to what type of bat?
Thanks.
Carole - in Elkton, MD where last night we saw a magnificent rainbow!
Carole Fox
cfox@dca.net
Marion Lyon on sat 1 jul 00
Hi....I don't know what a batt pin is, but since my wheel has a catch =
basin around it I found that I couldn't use my largest batts because the =
diameter of the basin was too small. I conquered the problem by cutting =
a ball point pen, minus the ink, into two short pieces. I then attached =
a smaller batt to the wheel, put my two measured pieces in the hole =
spaces still available and connected my bigger batt on top so it cleared =
the sides of the basin. You just have to be sure that the pins you've =
added do not reach the surface of the second batt. =20
Marion, in Massachusetts, enjoying the weather.. Excellent for the 4th =
of July weekend! =20
| |
|
