Sheron Roberts on thu 27 jul 00
Not too long ago I fired
a glaze load; program
was set for cone 10.
The kiln reached
1425 F and then an
error message showed.
I called Perry at Skutt
he told me to restart
the kiln, the temp
had dropped to a little
over 1100F. When the
kiln reached 1425 it=20
showed the error message
again. With Perry's help
via telephone and my
husband's knowledge
of electricity they=20
determined the problem
was not relays but a=20
short in the kiln
controller. Apparently
one of the relay wires
was loose and shorted
out. Perry sent new=20
wires at no cost to me
and my husband replaced
the burnt one. Problem=20
solved. So you might
want to have the relays
or the wiring checked inside
the controller.
Sheron in NC
By the way, the pots came
out fine after refiring them
to cone 10
| |
|
