Marjorie Beynon on wed 15 nov 00
I have only worked on an older Soldner wheel. The one with an almost half
circle table. I found it very hard on the back. I believe that was because
of the rigid table and braces. In order to be close enough to the wheel, my
knees were further apart than on my brent cx, therefore putting alot of
stress on lower back. I have noted pictures of Shankin and Glick with the
same type of wheel placed up on cement blocks. If possible try out a wheel
for a least a day before purchasing.
My back is not in very good shape so someone else would not necessarily have
the same problem. MarjB
----- Original Message -----
From:
To:
Sent: Tuesday, November 14, 2000 8:23 PM
Subject: Re: Wheel Recommendation
> Would anyone using a Soldner wheel like to
> comment about these? I'm thinking about
> buying one.
>
> Thanks in advance
>
> Maya
>
> Sellan, Mark wrote:
> >
> > Hello,
> >
> > I'm looking to buy an electric potters wheel for myself. I am a novice
and
> > want to have something good to continue learning on without spending a
> > fortune. Any recommendations would be greatly appreciated.
> >
> > Thanks much,
> >
> > -mark
> >
> > Mark Sellan
> > St. Louis Community College
> > Unix Systems Administrator
> > 314-539-5080
> >
> >
____________________________________________________________________________
__
> > Send postings to clayart@lsv.ceramics.org
> >
> > You may look at the archives for the list or change your subscription
> > settings from http://www.ceramics.org/clayart/
> >
> > Moderator of the list is Mel Jacobson who may be reached at
melpots@pclink.com.
>
>
____________________________________________________________________________
__
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached at
melpots@pclink.com.
| |
|
