search  current discussion  categories  tools & equipment - misc 

cool tool-leveling pots

updated fri 22 dec 00

 

Earl Brunner on thu 21 dec 00


Everyone using these or any other level while working on pots are making
sure that the surface that the pot is resting on is level as well? Right?
For example, I'm pretty sure that the floor in my garage (studio) slopes
and I have taken no steps to level my wheel, it works just fine. I can
"true" a pot to the spin of the wheel, but it probably isn't level. That
would also mean that the work table and slabroller are also off level.

Martin Howard wrote:

> These bulls eyes levels are a must IMHO for every pottery.
> I use them for assisting levelling ware on a chuck on the wheel;
> For checking that the pot is sits level after turning;
> For dipping ware in slip and glaze so that the line is always level;
> No doubt there are many other uses, but the above are important in most
> studios and most important, they are important to our purchasers.
>
> Martin Howard
> Webb's Cottage Pottery
> Woolpits Road, Great Saling
> BRAINTREE, Essex CM7 5DZ
> England
> martin@webbscottage.co.uk
>
> ______________________________________________________________________________
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached at melpots@pclink.com.


--
Earl Brunner
http://coyote.accessnv.com/bruec
mailto:bruec@anv.net

Norman van der Sluys on thu 21 dec 00


Earl - you can bet the surface of the glaze in your bucket is dead-on level!

Earl Brunner wrote:

> Everyone using these or any other level while working on pots are making
> sure that the surface that the pot is resting on is level as well? Right?
> For example, I'm pretty sure that the floor in my garage (studio) slopes
> and I have taken no steps to level my wheel, it works just fine. I can
> "true" a pot to the spin of the wheel, but it probably isn't level. That
> would also mean that the work table and slabroller are also off level.
>

--
Norman van der Sluys

by the shore of Lake Michigan, eighteen inches and counting