Nancy Guido on sun 2 sep 01
Hi Dale,
I recently had to replace the microchip in my computer for my PF2329D. You
may have to wait for the manufacturer's advice. While you are waiting, check
all the wires and make sure everything is attached properly. It may be as
simple as a loose wire. Check them all from the thermocouple straight
through to the computer. Email me direct if you want some guidance.
If its the microchip - well, the good news is that they sent it to me for
free, the bad news is that your work won't be done by Wednesday.
Nancy G.
Dale Cochoy on mon 3 sep 01
----- Original Message -----
From: Nancy Guido
Subject: Evenheat kiln, help
> Hi Dale,
>
> I recently had to replace the microchip in my computer for my PF2329D.
You
> may have to wait for the manufacturer's advice. While you are waiting,
check
> all the wires and make sure everything is attached properly. It may be as
> simple as a loose wire. Check them all from the thermocouple straight
> through to the computer. Email me direct if you want some guidance.
>
> If its the microchip - well, the good news is that they sent it to me for
> free, the bad news is that your work won't be done by Wednesday.
>
> Nancy G.
Nancy,
Thank you so much for the reply. That's the same model I have. I had one
other with an offer for a mother board if I need it. I was going to
remove/check stuff today ( holiday, off!) as you say, just in case. I'm
afraid you are right about the timing ( unless I stumble on it today), I'll
never be cooled down by Thursday once I go into Tuesday with repairs. When I
replaced the thermocouple from them last year they were very speedy about
sending it.
Regards,
Dale Cochoy, Wild Things Bonsai Studio, Hartville, Ohio USA
DaleCochoy@Prodigy.Net
http://www.wildthingsbonsai.com
| |
|
