Patrick Rowe on fri 22 mar 02
Here are the dimensions and a crude diagram for my Pacifica wheel stand. I
apologize for the delay but I have been out of town firing a kiln.
You need:
A 3 - 4"x4"x12.5"
B 2 - 2"x4"x24.5"
C 1 - 2"x4"x26"
D 2 - 2"x4"x14" cut at 45 degrees
Assemble the pieces according to the attached diagram. Then set your wheel
on the stand and nail strips of wood around the legs to hold them in place.
You can alternately drill 2" holes in squars of plywood and nail them on top
to hold the legs in place. You can raise the wheel by setting it on 2"x4"
blocks. I raise mine up some to make smaller pieces. This is a very sturdy
stand. It is easily portable and it will also hold a Brent wheel.
Use this stand to throw standing up ,invest in a Yoga stretching video and
save your back!
Patrick Rowe on fri 22 mar 02
If you would like the diagram I refered to, please e-mail me directly at
prowe@vol.com
-----Original Message-----
From: Ceramic Arts Discussion List [mailto:CLAYART@LSV.CERAMICS.ORG]On
Behalf Of Patrick Rowe
Sent: Friday, March 22, 2002 9:42 AM
To: CLAYART@LSV.CERAMICS.ORG
Subject: Pacifica Stand
Here are the dimensions and a crude diagram for my Pacifica wheel
stand. I
apologize for the delay but I have been out of town firing a kiln.
You need:
A 3 - 4"x4"x12.5"
B 2 - 2"x4"x24.5"
C 1 - 2"x4"x26"
D 2 - 2"x4"x14" cut at 45 degrees
Assemble the pieces according to the attached diagram. Then set
your wheel
on the stand and nail strips of wood around the legs to hold them in place.
You can alternately drill 2" holes in squars of plywood and nail them on top
to hold the legs in place. You can raise the wheel by setting it on 2"x4"
blocks. I raise mine up some to make smaller pieces. This is a very sturdy
stand. It is easily portable and it will also hold a Brent wheel.
Use this stand to throw standing up ,invest in a Yoga stretching
video and
save your back!
____________________________________________________________________________
__
Send postings to clayart@lsv.ceramics.org
You may look at the archives for the list or change your subscription
settings from http://www.ceramics.org/clayart/
Moderator of the list is Mel Jacobson who may be reached at
melpots@pclink.com.
| |
|
