Philip Poburka on mon 22 jul 02
an' ...the 'where' it be if ye can't find it,
or haven't the correct addresses...
Dear Marjory!
How aweful!
I am so sorry you could not get aholt of me!
...'phone as - (702) 388 - 2085, anytime...
...'e-mail' address, as per this message...
Sorry for difficulties reaching me...my 'phone had changed numbers awhile
back, I do forget to mention that sometimes...and, so far as the 'e-mail'
no-go, I gotst no ideee!
Looking forward to hearing from you!
Address as:
Bison Studios
1409 South Commerce Street
Las Vegas, Nevada
Regards,
Philip
ell vee
----- Original Message -----
From: "The Kline's"
To:
Sent: Monday, July 22, 2002 3:42 PM
Subject: Re: Bison Tools
> At 06:40 PM 7/21/02 -0500, you wrote:
> >I am not a regular on clay art but did notice the thread about Bison
Tools
> >and wanted to put in my two cents worth. I have purchased something like
ten
> >of Philip's trimming tools over the last 5 years and would not be without
> >them. They are some of the only tools I have used over the last 30 years
of
> >making pots that are a total joy to use every time. After a couple of
years
> >of constant use, the edge does get a little soft and I have sent them
back
> >for sharpening. I have broken one by dropping it so that is the only
> >negative that I have encountered. Although I did break one, I have
dropped
> >the tools many times without breakage.
> >If you make a lot of pots, indulge yourself in one of these tools and you
> >will be hooked too. Pure quality.
> >gary
> >
> >ps: six of those ten were gifts to other potters
> >
> >
> >Gary C. Hatcher
> >e-mail: gchfire@pobox.com
> >home/studio: 1-903-857-2271
> >university office: 1-903-566-7296
> >http://www.pinemills.com
> >
>
> I have a Bison tool that has been broken for a year at least. I have
tried
> to call Philip Poburka several times. I get "the number you have reached
> is not in service." I have e-mailed him, only to have my e-mail returned
> as not deliverable. What's going on? I read all these raves about this
> guy, who seems to have a lot of time to spend on sending messages to
> Clayart on various topics, but I can't get in touch with him. I just want
> to get the damn tool fixed.
>
> Marjory
>
>___________________________________________________________________________
> ___
> >Send postings to clayart@lsv.ceramics.org
> >
> >You may look at the archives for the list or change your subscription
> >settings from http://www.ceramics.org/clayart/
> >
> >Moderator of the list is Mel Jacobson who may be reached at
> melpots@pclink.com.
> >
>
>
____________________________________________________________________________
__
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached at
melpots@pclink.com.
| |
|
