pdp1@EARTHLINK.NET on wed 26 mar 03
One may also Trim 'dry'...
A sharp Tool and maybe a somewhat slower Wheel speed.
Set the work on thin foam-rubber, or, wet the Bat and hold
the work staionary as you rotate the wheel a little to make
a little slurrey at the rim or contact area, it will stay
put that way for a while...when it has wicked up that damp
as was holding it, merely lift the Work and wet the Bat
again, and repeat...
I did many that way...
Phil
Las Vegas
----- Original Message -----
From: "BVCuma"
To:
Sent: Wednesday, March 26, 2003 6:14 PM
Subject: RE :Rehydrating greenware
> At best, you can wet rags and wrap your pieces and then
put a plastic bag
> over the pieces in the attempt to re-hydrate the work
> ________________________
>
> Then set it out in direct sunshine
> (no shortage of it in India)
> Acts like a steamer...
> vaporizes the water
> ideal for equalizing rehydration.
> On opening..the sensation of moist hot pots in the hand
is....
> nice...even therapeutic.
>
> Bvcuma
>
> ps. if the pot is really dry
> and you need lots of moisture
> this technique works best if
> the rag in direct contact is just slightly damp...or dry.
> Then an outside rag can be very wet.
> Within hours everything is evenly hydrated,
> trim as usual... works like a charm.
>
>
____________________________________________________________
__________________
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your
subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached
at melpots@pclink.com.
| |
|