Cary Chleborad on wed 25 feb 04
O.K....
So my earlier post about developing a reasonably low cost thermocouple =
to PC
interface and the development kiln monitoring software has piqued the
interest of a few. In response I put together a short pdf outlining the
system. Get it at: www.telescopebuilding.com/PCKilnMonitor.pdf
-Cary
piedpotterhamelin@COMCAST.NET on fri 27 feb 04
check this out
http://home.austin.rr.com/bevhoward/kiln/KilnCtrl.htm
I too, am looking into this.
Arnold told me Omega also makes an interface.
Anyone know of some software for this?
Rick
--
"Many a wiser men than I hath
gone to pot." 1649
> O.K....
>
> So my earlier post about developing a reasonably low cost thermocouple to PC
> interface and the development kiln monitoring software has piqued the
> interest of a few. In response I put together a short pdf outlining the
> system. Get it at: www.telescopebuilding.com/PCKilnMonitor.pdf
>
> -Cary
>
> ______________________________________________________________________________
> Send postings to clayart@lsv.ceramics.org
>
> You may look at the archives for the list or change your subscription
> settings from http://www.ceramics.org/clayart/
>
> Moderator of the list is Mel Jacobson who may be reached at melpots@pclink.com.
| |
|
