Gary Harvey on mon 26 apr 04
Just a suggestion but why remove the wax it will burn off in the kiln when
fired?
----- Original Message -----
From: "MarjB"
To:
Sent: Tuesday, January 21, 2003 3:37 PM
Subject: [spam] Re: Clean Glazing Wax Problems
Morning:
I was glazing a few pieces recently and wanted the inside one glaze, outside
another with clean line... I waxed the glazed rim and some of the interior.
My wax has peeled off or lifted. Unlike latex resist, it removes some of
the glaze. My wax is Baileys. It acted like a shivered glaze. Paper thin
lifted segments. I tried waxing sooner and waxing later - same results. A
mess.
I haven't tried a heated wax mix as yet. Is it just the Bailey's wax?
timing? underlying glaze? I did not thin the Bailey's and applied a
relatively thin coat. Any suggestions to this puzzle ? Thank you - MarjB
____________________________________________________________________________
__
Send postings to clayart@lsv.ceramics.org
You may look at the archives for the list or change your subscription
settings from http://www.ceramics.org/clayart/
Moderator of the list is Mel Jacobson who may be reached at
melpots@pclink.com.
| |
|
