search  current discussion  categories  kilns & firing - elements 

help with elements?

updated fri 5 nov 04

 

Randy McCall on thu 4 nov 04


I am putting the elements in a skutt 1027. I have the elements in an =
now am putting the connectors to the box. I clamped the connectors to =
the box wires and before I took them off I numbered the wires 1, 2, 3, =
and 4.
1 going to the top element, 2 going to the same element but down one. I =
got three and four on according to the sequence, but then put 1 where I =
should have put 2. It goes to the same element. Will it make a =
difference with the switch if I leave it as is or am I going to have to =
cut the connector off and put it on as numbered?

I really did not want to have to cut the connector off unless I =
absolutely have to.
I know, I know pay attention right................

Randy