search  current discussion  categories  techniques - misc 

using shellac as a resist

updated sun 16 oct 05

 

John Connolly on thu 13 oct 05


This is my second message to the board. I have to say again how impressed I am with the level of information shared here.

I have been fascinated by the concept of using shellac as a resist. My carving skills are nil and this seems a way to get carved effects in a much less (for me) frustrating way. I immediately used the technique on a leatherhard piece. However, my teacher is not accustomed to the idea and concerned about damage to the kiln elements. I attend a university in Baja California, Mexico and things do not always have the same names. Is there a danger of leaving deposits on electric elements at bisque temperatures? What about other downsides to shellac?

John Connolly






---------------------------------
Yahoo! Music Unlimited - Access over 1 million songs. Try it free.

Ivor and Olive Lewis on sat 15 oct 05


Dear John Connolly,=20

You ask << What about other downsides to shellac?>> Since it is an =
alcoholic solution you may get a little light headed or squiffy if you =
spend a long tame at the task in an enclosed space ! !

But the stuff burns out at a very low temperature and should have no =
real effect on the elements of an electric kiln.

By the way, though it does not employ sculpting or modelling skills you =
do need to have a good had with a brush.

Have fun.

Best regards,

Ivor Lewis.
Redhill,
S. Australia.